I haven't used my G4 Cube for about a month, and when I put my finger on the heat sensor which is supposed to start it up, it wouldn't respond. I know for sure that the outlet works, so I'm just trying to figure out what could be going on here. Can anyone enlighten me?
This page is a wiki. Please login or create an account to begin editing.
2012, February 6 - 3:30am
#1
'Cube' won't start
Comments
2012, February 6 - 3:39am
#2
Clock battery is the 1st item I usually check. Should be 3.6 volts. Below 3.0 volts can cause some Macs not to start if they haven't been connected to a power source for a while.
2012, February 6 - 8:58pm
#3
"ZOop!" It starts right up after three minutes of installation and two minutes of charging.